The Azteeg 3DP is an open source controller designed to be used in RepRap 3D Printers and similar cartesian based machines including CNCs. It has all the features needed to run all current and future single extruder designs.

The Azteeg is based on Sanguino/Sanguinololu and is compatible with most Arduino based firmware(Sprinter,Marlin,Repetier, plus others.). It is pin to pin compatible with the Sanguinololu with the addition of a FAN PIN. The Azteeg features mostly SMT parts to ease production and reduce cost.

 

Features:

Atmel ATmega 644P with FT232RL FTDI USB chip

Compatible with Sprinter, Marlin, Repetier, others.

High current capacity connectors and PCB traces.

Mosfet control for 1 extruder and 1 hotbed

Extra PWM control for small fan or LEDs

3 end stops and 2 thermistor inputs

12-30v input high efficiency switching Power supply @ 500ma max

Dedicated uSD card female header [SDRAMPS compatible]

Low RDSon Mosfets for less heat buildup

Input power selector for micro controller [USB or internal regulator]

Secondary power input for stepper motors.

Optional pads for TVS spike suppression diodes for the Mosfets

Mosfet Heatsinks included

i2C, Tx1 serial, +5, GND, SPI and ADC pins on the expansion ports

Fast acting blade fuse

Both right angle and vertical connector sets included

Lots of LEDs, PWR, hot end and hot bed